Automotive Windshield Protection Film

Replacing a windshield is expensive and frustrating, and on most modern vehicles it means recalibrating the cameras and sensors mounted to the glass. Windshield Protection film helps prevent the chip in the first place and avoids all of it.

• Chips stop at the film, not the glass. In gravel impact testing at up to 70 psi*, Clearshield WPF came away with no more than four marks smaller than a pencil tip.
• It stays clear as it ages. After 5,000 wiper cycles with grit on the glass, haze stayed under 1%. Wipers are what usually cloud a film, so this is the number that matters over years, not weeks.
• Cooler cabin, less fading. Rejects 24% of the sun’s heat and blocks over 99% of UV.
• Built to take weather and chemicals. No degradation after heat aging at 248°F, or after soaking in washer fluid, alcohol, or soap and water.
• Installed by certified dealers. Applied professionally for a clean, bubble-free finish.

_{*8A or better under SAE J400 gravelometer testing. Haze measured to ECE R43 and ASTM D1003. Solar performance calculated using NFRC methodology.}

• What to expect after installation. You may notice slight haziness in the first few days. That’s moisture left under the film during installation, and it clears on its own as it dries.
• Keeping it clean. Mild soap and water is all it needs. Rinse first so grit doesn’t get dragged across the surface, then wipe with a soft microfiber cloth. Avoid ammonia-based cleaners and abrasive pads.
• Two things to avoid.
  • Don’t run your wipers on dry glass. Spray washer fluid or water first, the same as you would to avoid scratching the windshield itself.
  • Don’t use an ice scraper. Use a de-icing spray or warm water to soften ice, then clear it with a soft cloth or gloved hand. Never use boiling water, which can thermally shock the glass.
• Clearshield Ceramic Spray. Designed specifically for Solar Gard our ceramic spray coating delivers up to six months of resilient protection in every application.